UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
· CURA slicer, gaps between inner walls and infill
Zooming in on the photo of the 4 gears they are 15 to 20% under-extruded. Before you start changing other settings I think you need to address that. The center walls of the hole for the shaft look more like hex's than circles. I think that's because the plastic wasn't getting smashed down and instead it was dragging in towards the centerline of the hole.
This is your photo. I've added some red lines where there is under-extrusion. Fixing it might be as simple as calibrating the E-steps. It could be other things as well but that's where I'd start.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
GregValiant 1,342
Zooming in on the photo of the 4 gears they are 15 to 20% under-extruded. Before you start changing other settings I think you need to address that. The center walls of the hole for the shaft look more like hex's than circles. I think that's because the plastic wasn't getting smashed down and instead it was dragging in towards the centerline of the hole.
This is your photo. I've added some red lines where there is under-extrusion. Fixing it might be as simple as calibrating the E-steps. It could be other things as well but that's where I'd start.
Link to post
Share on other sites