There is no Klipper firmware selection

[Snowist 0]

When I add a new printer dialog box asks for printer firmware but there is noKlipper listed there.

Come on, Klipper is known as a highend firmware for mostly for corexy printers and widely used. 

Please add that.

[Dim3nsioneer 558]

Since none of the Ultimaker printers runs with this specific firmware it would be a community job to add it since Cura is open source. Maybe you want to suggest it directly on Github or even provide the necessary code there? 😉

[GregValiant 1,436]

Are there some Gcode or Mcode commands in Klipper that differ from Marlin?  I've read that Enders equipped with Klipper will run Gcode sliced for Marlin.