Stringing Not going away

[SidneyRFarmer 0]

I keep having this stringing problem happen and the supports are not sticking and becoming really stringy. 

I have been messing with setting trying to figure out what is wrong with it, and it is happening on all of my prints with the Ender Pro 3

Can't figure out what the problem is. if you want to look at the Gcode and help or give any tips

the walls when I print as well are not there and on the outside of my prints it is just building the supports and not the walls.

Using an

Ender Pro 3, Pla 1.75

207111714_CE3PRO_belowflowerpart2.gcode

Edited January 16, 2022 by SidneyRFarmer

[servant74 1]

It has helped me to LOWER the print temp a little, and to increase the retraction quite a bit (8mm where default is 4 if I remember right). 

 

I use Cura on my Ultimaker 3, but the basics should be simi