UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
QUESTIONIs it possible to have both AA25mm and AA40 print cores installed at the same time?
Posted
· Is it possible to have both AA25mm and AA40 print cores installed at the same time?
Yes, that is certainly possible. Each extruder has its own profiles. If you want to select a profile for the second extruder, you have to select that extruder above the setting list.
One thing to realise is that because Cura generally can not "mix" different layer heights in a single layer, both extruders will need a profile with the same layer height. This limits the available profiles of you mix two different extruders. You can get around this by going in the extruder configuration in Cura and disabling the extruder you don't use.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
ahoeben 1,981
Yes, that is certainly possible. Each extruder has its own profiles. If you want to select a profile for the second extruder, you have to select that extruder above the setting list.
One thing to realise is that because Cura generally can not "mix" different layer heights in a single layer, both extruders will need a profile with the same layer height. This limits the available profiles of you mix two different extruders. You can get around this by going in the extruder configuration in Cura and disabling the extruder you don't use.
Link to post
Share on other sites