There is a problem with single wall prints

[RadoBG_MTB 0]

I have a singel wall boat but only the suport for it get sliced. the wall thicknes is 0.16 and the leyer hight is 0.16. What is wrong?

[Smithy 1,146]

With wall thickness, do you mean the wall thickness of the model or the setting in Cura?

You can try if it helps to enable the setting "Print Thin Walls"

I never had the need to print a single wall, but as far as I know Cura don't print just a single wall. Cura always prints 2 walls, except you print in vase mode.