Thank you for the quick reply and also for the under-extrusion tip. I've attached the 3mf as requested!
GregValiant 1,342
In the "Top/Bottom" settings - set the "Skin Removal Width" to 0.1.
Cura is removing the "skin" from under the letters where the letters are wide enough that the "skin removal width" would apply. If you look close you'll see that the "M" in particular has wider parts at it's points.
For a comparison - set the "Skin Removal Width to 2.0 and see what happens.
Edited by GregValiant-
1
Thank you!! This seems to have resolved the issue! It was making me nuts! Great explanation of the issue and the resolution! Trying the print now!
Recommended Posts
GregValiant 1,342
If you can share the model use the "File/ Save Project" command in Cura and post the 3mf file here.
Off topic, that top layer is under-extruded by 10% or so.
Link to post
Share on other sites