Top Layer Issue Cura

[thirdofive 0]

I am stumped. I have tried every setting.

I am using a .6mm nozzle and for some reason the top layers (3) (Lines) do not alternate they always print in the same direction.

The bottom of the prints alternating but not the top.

I hate the way it looks when it prints 3 layers of lines the same direction every time.

Any way to change this?

I want alternating lines for the top of flat surfaces.

[Paul_Inspire3D 0]

Do you have Enable Ironing turned on for the top layers? 

 

You could also try to create alternating angles using the Top/Bottom Line Directions tool.