Bug How can coexist Chitubox and Ultimaker Cura in the same PC?

[Roger007 0]

I have 3D filament printer and 3D Resin printer, so I need both softwares but if I have both installed Ultimaker Cura crash and close when I opened it.

 

Chitubox works fine just Ultimaker Cura dont, the workaround is uninstalled chitubox, but I need it

 

You have a patch or something to work with both softwares in the same PC?

 

Regards

[ahoeben 2,010]

4 minutes ago, Roger007 said:

the workaround is uninstalled chitubox

There is another workaround, which is to disable only the explorer thumbnail created by Chitubox. This workaround is outlined here:

https://support.ultimaker.com/hc/en-us/articles/4402996140946-Ultimaker-Cura-crashes-when-opening-any-file

[nallath 1,124]

The Cura 5.0 release should also solve the problem, but you will have to wait a bit until the release.