Jump to content

Rerun the same job from the printer panel


gedp

Recommended Posts

Posted · Rerun the same job from the printer panel

Hi,

 

I thought, when a print job was finished, I could start the same job again from the front printer panel without going through Cura on my mac. Have I dreamed or am I looking over it?

 

Thx,

Geert

  • Link to post
    Share on other sites

    Posted (edited) · Rerun the same job from the printer panel

    History is not stored by the printer.

     

    You could look at the printer (IP Address) from your browser ( on phone or Tablet ) and select "Management Console"

     

    image.png.465944560a9e6045079bcae13cfa74a8.png

     

    Scroll down to "Recent History" and click on "RE-PRINT"

     

    image.thumb.png.c593411cd272fd96ff28e4fed2b7c406.png

     

     

    Edited by Carbon
  • Link to post
    Share on other sites

    Posted · Rerun the same job from the printer panel

    It does seem to keep the memory of the most recent job as you can have the option to retry if a print is aborted, but there doesn't seem to be a way to do it after a successful print. I, too, thought this would be a handy option to have, maybe at the "confirm build plate is clear" screen.

  • Link to post
    Share on other sites

    Posted · Rerun the same job from the printer panel

    Completely agree-  not  sure what the logic  in not having that function.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 7 replies
      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
    ×
    ×
    • Create New...