staggered layers possible ?

[wolfdeh 0]

 

Hello, I need to do tubes. Yes, silly idea anyway. And they should be thin-walled - even more silly. With standard printig, I get predetermined breaking points between each layer. If I could stagger the layers, that would be much less of a problem and I had a much stronger tube   Image here   Can that be achieved in Cura?   Cheers, Wolf

[ahoeben 1,968]

On 4/12/2022 at 11:00 AM, wolfdeh said:

Can that be achieved in Cura?

Not without altering the generated gcode. Cura will generally allow only a single Z position within a single layer, and no overlaps between layers. The only exception is spiralized printing ("vase mode"), but that only gives you a single wall.