Jump to content

I need Help with my ABL

Foxtrix
 Share

Recommended Posts

Foxtrix

Foxtrix 1

Posted
Posted · I need Help with my ABL

So I have an cr touch on my ender 3 v2 and when I try to print something it only goes to one of the 25 probe points that are on. I use Jyers UI. When I try to create a new mesh it only goes to one probe point and says save. it just started doing that yesterday and I don't know what could of happened.  I flashed the firmware and reinstalled the orginal software then Jyers Ui again but It still has the same problem. I put in the correct mother board when downloading the software. Can you please help 

    • Link to post
    Share on other sites
    GregValiant

    GregValiant 1,309

    Posted
    Posted · I need Help with my ABL

    I'm pretty good with the Creality machines but I can't help with the CRTouch.  There is some information on the Marlin Site regarding M420 that you might be able to use to reset the mesh (or enter a new one).  That is provided that a couple required settings are enabled in your firmware.

    Have you asked about this over on Reddit?  The Ender 3 Group is a big one and the Jyers firmware is a popular alternative to the stock firmware.

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • Introducing the UltiMaker Factor 4

        Introducing the UltiMaker Factor 4

        ArunC posted a topic in UltiMaker 3D printers,

        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
        MariMakes

        Picked By

        MariMakes,
      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...