5.0 takes a brake

[Smokie 0]

cura5.0 pauses at random times, moves to a position next to print and resumes print after +- 15 sec
got an ender 6 , then back to 4.13.1 and problem solved

wr,Henk

[GregValiant 1,342]

How are you printing?  SD card, Octoprint, USB?

[Smokie 0]

Hello Greg, mostly by sd card

But in 4.13.1 the problem is gone

Wr,Henk

Edited June 10, 2022 by Smokie

[GregValiant 1,342]

There were some issues with the USB Printing plugin of 5.0beta.  I know it was worked on a bit but I'm not sure what changes were made.

I always print from the SD card and I haven't seen any issues with pauses.  There is a setting in 5.0 (and 4.13) in the Experimental section called "Wipe Nozzle Between Layers" that can cause some movement away from the print.  It has a sub-setting called "Wipe Pause".  I've never used them so I'm not sure what they entail.  Make sure you have them turned off in 5.0.

You can also post a problem gcode file and I'll take a look.

[Smokie 0]

Hoi Greg,if turned all back to 4.13 

 But mabay later ill try 5.0 again and look at these setting

Fore now thanks

Wr Henk