On 6/19/2022 at 8:52 PM, GregValiant said:Those are very consistent 125% numbers. There are some new settings in Cura 5.0 in the Material section.
Use the Setting Visibility tool and set visibility to "All" and then make sure your "Scaling Factor Shrinkage Compensation Factors" are all set to 100%.
Recommended Posts
GregValiant 1,342
Those are very consistent 125% numbers. There are some new settings in Cura 5.0 in the Material section.
Use the Setting Visibility tool and set visibility to "All" and then make sure your "Scaling Factor Shrinkage Compensation Factors" are all set to 100%.
Link to post
Share on other sites