UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I'd contact your reseller. They can help you fix this.
Or you can go all "manual leveling" if you prefer that route. I did manual only for a few months on my S5 but eventually went back to the active leveling. To go manual use this tool:
We've been fighting this same issue. Our printer was great for ~9mos now it is nothing but problems. The entire hot end assembly was changed - both cores, hot end board, inductive sensor, fans, all new. Customer service blamed it on bent fan wires(???) and bad power - We have two printers 80 miles apart and both have the same issue. My solution is a custom profile and disable core 2. We're moving on to Bambu Labs. All the performance, 1/10 the cost.
1
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,235
I'd contact your reseller. They can help you fix this.
Or you can go all "manual leveling" if you prefer that route. I did manual only for a few months on my S5 but eventually went back to the active leveling. To go manual use this tool:
https://community.ultimaker.com/topic/39188-ultituner-a-tool-to-tweak-your-printer
Link to post
Share on other sites
JonCxW 1
We've been fighting this same issue. Our printer was great for ~9mos now it is nothing but problems. The entire hot end assembly was changed - both cores, hot end board, inductive sensor, fans, all new. Customer service blamed it on bent fan wires(???) and bad power - We have two printers 80 miles apart and both have the same issue. My solution is a custom profile and disable core 2. We're moving on to Bambu Labs. All the performance, 1/10 the cost.
Link to post
Share on other sites