Vase Bottom Layer Help

[Brandon5799 0]

Hello I’ve recently gotten into printings various vases for the artistic side and how they show off printer and filament quality too. Anyhow for the life of me I cannot change the bottom layer, it automatically sets the bottom layers to a spiral pattern except if I enable ironing but only the ironing pattern option works. No matter what I set the bottom layer or layers to they are made into an inner wall layer and I can’t change the pattern no matter what pattern I select. I’d like to have my bottom layer a zigzag pattern for better cosmetics and rigidity. Any advice or help is appreciated thanks!!

[GregValiant 1,035]

The only bottom pattern available when using Spiralize in Cura 5.x is "Concentric".  It is "Expected Behavior" and not a bug.

There have been a number of people not happy about this.

@nallath might have more on this topic as it has come up both here and on Guthub.

[Brandon5799 0]

35 minutes ago, GregValiant said:

The only bottom pattern available when using Spiralize in Cura 5.x is "Concentric".  It is "Expected Behavior" and not a bug.

There have been a number of people not happy about this.

@nallath might have more on this topic as it has come up both here and on Guthub.

Is this new in 5.0? Can I use a 4.?? Version or is it different in 5.1, I haven’t had time this week to try it yet. I got my hopes up when I saw the bottom layer pattern option but nope. Maybe there’s a script that can be used to make the bottom layer something different possibly idk??

[GregValiant 1,035]

You would need to drop back to 4.13 or prior.

[Brandon5799 0]

1 minute ago, GregValiant said:

Nice and thanks!