Jump to content
Ultimaker Community of 3D Printing Experts

travel within inner wall only?


greens83
 Share

Recommended Posts

Posted · travel within inner wall only?

Hello Cura aficionados. I'm hoping someone might be able to tell me If something is possible in cura.

 

I'm trying to print some honeycomb attachments for light fittings (to reduce glare)

 

I'm doing this by using honeycomb infill and having n top or bottom layers.

 

I've attached a screenshot. It prints ok but I get stringing where the nozzle travels over the infill.

 

Is there anyway to get the travel to follow the inner wall around the perimeter or stay within the infill paths?

 

I have played with combing settings but it always travels straight across the infill.

 

Any suggestions or input very much appreciated.

 

 

Screenshot 2022-08-03 09.08.15.png

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 13 replies
    ×
    ×
    • Create New...