Would it be fair to ask a question on a non Ultimaker printer?

[3AM 0]

I have a Creality Ender 3 s1 pro. It has 2 jack screws (threaded arms) on each side of the vertical braces. The extruder rides on a rail that has a knob to tighten the belt at the back running horizontally. The threaded arms control the vertical motion. At the very top of the arms is another belt running from one arm horizontally to the other. This belt has no tightening knob and is loose. It should be snug. just wanted some help before I mess it up. 

Thanks

Edited August 27, 2022 by 3AM

[FaithV 0]

Here I have included a chart for an Ender 3 s1 Pro. P.S. it is not cheating. actually i have questions about my Monoprice Ultra almost every chat. I just have the app for Cura.

[FaithV 0]

🙂 totes not cheating.

[3AM 0]

Chart? I dont see a chart or maybe its just me

[FaithV 0]

here, I'll send it again...

[FaithV 0]

Better?

 

[FaithV 0]

can you see it??

 

[3AM 0]

1 hour ago, FaithV said:

here, I'll send it again...

This is a picture of stepper motor located on the base. Not the belt that runs across the top from side to side

but thanks anyway

 

[FaithV 0]

so sorry, I will keep researching until I find a blue print for this part. Is there a small like parts map in your manual?

[FaithV 0]

totes fine if there isn't, sorry I didn't read that properly...

[FaithV 0]

🙂