I like it Fuzzy and Shaved

[GregValiant 1,320]

I wasn't aware it would be in ASA so yeah, print speeds will be lower.

I don't know that you can get a lot better than that.  Slower speeds would clean it up just a bit more but if you intend production then that will hurt more than it helps.

 

When I show someone a print they never notice things like Z-seam location or elephant foot.  They might notice print quality if it's bad.  I'm pretty fussy and if I think a print is acceptable then it isn't likely that anyone who doesn't 3D print would notice any flaws it might have.  FDM prints are not going to be the same as an injection molded piece but even a nice injection molded part will have parting lines and vent circles and other flaws that are part of the process.

[Kotaztrafee 2]

It seems the definition on the body is more defined than the text according to the setting I made in the blocker. Does the blocker not affect the text? Do you see that also? You mentioned an additional blocker just over the text with settings just for the text correct? So one blocker can be within another? If I were to do this would I need a custom blocker? If so, can you direct me to how to make a custom blocker if that is the case.

I realize there will be visible lines but I want to try to get it as good as possible. Nice thing about fuzzy skin is it doesn't have lines  :-)