4 hours ago, MariMakes said:Hey @cato825,
Welcome to the Ultimaker Community 🎉
Any idea if you have a lot of printing hours on your printer?
If you are showing signs of underextrusion it might be time to replace your TFM coupler. Instructions on how to do that can be found here:
https://support.ultimaker.com/hc/en-us/articles/360020687040-How-to-check-and-replace-the-TFM-coupler-on-the-Ultimaker-2-Connect
We also have this generic support page that helps to improve printed party quality.
You can find it here.
Do you know if it's just this printjob that is failing? Do you have a project file for us?
To save a project file go to File -> Save project.
Than we can troubleshoot together. 💪
I don't know how many hours but I use it for production so I imagine it has quite a few. I will try that. Thanks!
Recommended Posts
MariMakes 204
Hey @cato825,
Welcome to the Ultimaker Community 🎉
Any idea if you have a lot of printing hours on your printer?
If you are showing signs of underextrusion it might be time to replace your TFM coupler. Instructions on how to do that can be found here:
https://support.ultimaker.com/hc/en-us/articles/360020687040-How-to-check-and-replace-the-TFM-coupler-on-the-Ultimaker-2-Connect
We also have this generic support page that helps to improve printed party quality.
You can find it here.
Do you know if it's just this printjob that is failing? Do you have a project file for us?
To save a project file go to File -> Save project.
Than we can troubleshoot together. 💪
Link to post
Share on other sites