UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
GregValiant 1,342
A line like this:
M140 S60{material_bed_temperature_layer_0} ; Set Heat Bed temperature
is wrong. What is happening is Cura is adding your bed temperature and so the line becomes
M140 S6060
and the hot end becomes
M104 S215215
Which is probably a tad on the warm side.
So change those 4 lines that have the replacement words in them and remove the numbers after the "S"
M140 S{material_bed_temperature_layer_0}
M104 S{material_print_temperature_layer_0}
Your M104 S170 line is fine since nothing gets added too it and the nozzle shouldn't ooze at 170.
Link to post
Share on other sites