Hey @Nissandriver,
Welcome to the Ultimaker Community 🚀
@nallath is correct, we've had a lot of report about this and we've added a ticket to the backlog with the intent to improve this. You can read more about it here https://github.com/Ultimaker/Cura/issues/8229
Untill the fix is implemented, please make sure to remove the + from the PLA+ in your material type. The + in the material type is confusing Cura and it cannot find the profiles for the layerheights you want to refer to.
Thanks for the report! 👍
Recommended Posts
nallath 1,118
https://github.com/Ultimaker/Cura/issues/7276
Link to post
Share on other sites