27 minutes ago, MariMakes said:Did you try changing the bay where the material is loaded?
thanks, yes i did. no difference, exactly the same behavior. I had tried material bay B2 and E2, with no difference.
Note that placing ASA filament instead of TPU (so pretending it was TPU) did feed correctly, so it must have to do with the flex of the filament relative to feeder progress detection sensor items or path differences it goes.
thanks for checking on other tips.
Edited by flyinggorilla
Recommended Posts
MariMakes 203
Hey @flyinggorilla,
That's quite odd behavior and it doesn't sound familiar.
Flexible materials should be available in both extruders!
I've heard some stories where the material bay had influence on the ease of loading materials.
Did you try changing the bay where the material is loaded?
Perhaps, if something is stuck in your bay you can follow these steps to clear the tubes out
https://support.ultimaker.com/hc/en-us/articles/360012325219
I'll ask around if there are other tips to help with troubleshooting 💪
Link to post
Share on other sites