UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
You can do this with mesh modifiers. You can add a cylinder that only includes the outer or only the inner edge and modify the wall thickness for just that region.
The video below explains it. Maybe skip to about 3 minutes into the video. Unfortunately the video is 6 years old so the cura interface changed a little but not much. I think you can figure it out.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,224
You can do this with mesh modifiers. You can add a cylinder that only includes the outer or only the inner edge and modify the wall thickness for just that region.
The video below explains it. Maybe skip to about 3 minutes into the video. Unfortunately the video is 6 years old so the cura interface changed a little but not much. I think you can figure it out.
Link to post
Share on other sites