Jump to content

¿Alguien puede ayudarme para imprimir con PLA con fibra de carbono?


Artesanowallets

Recommended Posts

Posted · ¿Alguien puede ayudarme para imprimir con PLA con fibra de carbono?

Hola,

Tengo que imprimir una tapa de ventilación para una caravana, pero tengo algunas dudas en la elección del material. Debido a estar en un vehículo que va a tener vibraciones y va a estar al aire libre aguantando las inclemencias del tiempo, creo que sería mejor imprimirlo con algo más resistente como PLA con un porcentaje de fibra de carbono. ¿ Alguien tiene experiencia en imprimir con PLA con Fibra de carbono? ¿puede orientarme? Gracias.

trapa1.3mf

  • Link to post
    Share on other sites

    Posted · ¿Alguien puede ayudarme para imprimir con PLA con fibra de carbono?

    Hola,

     

    Lo siento, no puedo hablar español, pero creo que puedo ayudarte.

     

    Thanks for your question 👍

    In my experience PLA does not hold up well inside of a car, it will become pliant/soft at around 50 degrees celsius, which is a temperature that a caravan in the sun can reach.

    For this solution I would go for PETG or ASA. 
    ASA has the added bonus that it will likely not decolor in the sun since it's made for outside use.

    I hope this helps 😄

    Buena suerte

    • Like 1
    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...