Time remaining extension under Cura 5.1.2

[cfrank01 0]

I've been using the Display Progress on LCD extension for quite some time but now notice its not displaying correctly on my Ender 3 Pro.  It will show the time when the print first starts but in a few seconds, it will show DST 1.0mm.  This value will change as the print progresses. No idea why its doing this.  I'm using Cura 5.1.2.

[GregValiant 1,287]

Do you have other post-processors active?  They run in the order they are listed.  If you have others active then maybe one of them is over-writing the M117 line in the gcode.

[cfrank01 0]

I have no other extensions running

[GregValiant 1,287]

Post a gcode file that shows that behavior and someone will take a look.  At every layer in the gcode there should be a line like:

M117 Time Left 0h21m35s

Is that the format you are used to seeing (Time Left 0h21m35s)?