How to print both surface and solid

[mikedkelly 0]

Are there settings in Cura to print this object? I can do it by adding enough bottom layers to print the solid, but then the large circle prints with those layers as well. I need the large circle to print as a single wall. The solid part is thin enough that it does not require infill, but either way is fine. Thanks for any suggestions.

[Cuq 202]

In Special Modes switch the Surface Mode to  Both 

[mikedkelly 0]

Thanks for the reply. I tried that before posting but it didn't seem to make a difference. I am attaching the stl file for reference.

Surface-solid Test.stl

[GregValiant 1,287]

Here's my try.

 

GV Surface-solid Test.3mf

[Cuq 202]

In such case ( and if the design of the part is the real final design and not a sample part) I would use a Cylinder as Cutting Mesh Modifier for the bigger cylinder.

 

[mikedkelly 0]

Thank you both for your suggestions. This was the simplest representation of my part, but you've really opened my eyes on what is possible.