Set build chamber temp in start gcode.

[JPasternack 0]

I have my heated chamber setup in cura, but it does not start heating the chamber until right before the print starts. is there a command that I can add to my start gcode to set the temp when it sets the temp for the build plate and hot end? if I could do that or just have the chamber set to 35c less then the build plate would be perfect. 

[GregValiant 1,330]

M141 S sets the chamber temperature.  M191 S sets the chamber temperature and waits while it gets up to temperature.

 

M191 S{build_volume_temperature} in your startup should work.  M191 must be configured in your firmware.

[JPasternack 0]

Thank you for your help, that worked.