Jump to content

First pass of bridging always droops badly, but second pass is near perfect.


shiang1311

Recommended Posts

Posted · First pass of bridging always droops badly, but second pass is near perfect.

Printer: Ultimaker S5
Material: Ultimaker tough PLA
Firmware: 7.1.3.0

The first strand of a bridge always has very bad drooping, but the second strand is near perfect, lost on which setting to adjust.

 

Using Cura slicer with experimental bridge settings enabled. Tried lower temps, lowering speed, and lowering flow rate. All seems to only apply to the strands after the first, leaving a single strand drooping from what is otherwise a very decent bridge.

20230125_155854.jpg

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...