My Printer changes direction

[doubird1 0]

I use cura with my Duplicator Mini i3. Most of my prints, i use a brim.  Bed adhesion is ok.  The problem i noticed is that when the brim is done, the printer changes direction to print and often leaves either a blob or a small line of filament that after gets in the way. Is there a way to fix this? Is it a Cura settings problem? Thanks for any help.

[MariMakes 203]

Hey @doubird1,

 

Do you have a picture of your problem, and a  project file for us? It contains the printer and settings we need for troubleshooting.  To save a project file go to File -> Save project.

 

I think your issue might be solvable with the correct combing and retraction settings. 
Or you could be running into an issue similar to this one:  

 

[doubird1 0]

On 1/30/2023 at 7:56 AM, MariMakes said:

Hey @doubird1,

 

Do you have a picture of your problem, and a  project file for us? It contains the printer and settings we need for troubleshooting.  To save a project file go to File -> Save project.

 

I think your issue might be solvable with the correct combing and retraction settings. 
Or you could be running into an issue similar to this one:  

i saved the project and uploaded. hope it helps to understand. 

 

barMount.gcode barMount.3mf