UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I have "inside to outside" enabled in Cura but the print order its giving me is inside, outside, then inside. See pic. Anyone know why?
I also wasn't really sure what was happing in your print so I showed it to the team.
They referred me to the description of the Wall Ordering Setting:
"Determines the order in which walls are printed. Printing outer walls earlier helps with dimensional accuracy, as faults from inner walls cannot propagate to the outside. However printing them later allows them to stack better when overhangs are printed. When there is an uneven amount of total innner walls, the 'center last line' is always printed last.",
What you are seeing, is the Center Last Line, which is always printed last.
I think that it's an odd wall, so if it's heavily impacting your print quality you can try to change the Minimum Odd Wall Line Width.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
MariMakes 204
Hey @Jhawk6553,
I also wasn't really sure what was happing in your print so I showed it to the team.
They referred me to the description of the Wall Ordering Setting:
"Determines the order in which walls are printed. Printing outer walls earlier helps with dimensional accuracy, as faults from inner walls cannot propagate to the outside. However printing them later allows them to stack better when overhangs are printed. When there is an uneven amount of total innner walls, the 'center last line' is always printed last.",
What you are seeing, is the Center Last Line, which is always printed last.
I think that it's an odd wall, so if it's heavily impacting your print quality you can try to change the Minimum Odd Wall Line Width.
Link to post
Share on other sites
Jhawk6553 8
@MariMakes Yet again, you are the best! Thank you!
Link to post
Share on other sites