UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Need Assistance: Why are the supports not showing up on my sliced model? And why does it not fully render in preview mode after slicing?
Posted
· Need Assistance: Why are the supports not showing up on my sliced model? And why does it not fully render in preview mode after slicing?
Hi
I had the same problem that supports weren't showing in preview.
After a few minutes checking and messing around, I noticed that you have to have the "helpers" box checked on the Preview screen and click Material Colour, than check the helpers box.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
MariMakes 199
Hey @Aardwolf_Productions,
Welcome to the Ultimaker Community 🎉
Sorry, it took us a while to get back to you 😞
Are you still stuck?
Supports should only be showing up in Preview mode.
It's the middle one of the three buttons at the top.
If that's not it we might need some more information from you, like your Cura Version.
Do you have a project file for us? It contains the printer and settings we need for troubleshooting.
To save a project file go to File -> Save project.
Link to post
Share on other sites