Jump to content

S7 won't Connect to WiFi or print


Recommended Posts

Posted · S7 won't Connect to WiFi or print

New S7 and material manager.
It will Not recognize the WiFi. The S5 is online with the same WiFi and has never had an issue. . When I try to print, it enters an endless loop of pop ups asking me to load material that is already loaded. Clicking abort or ignore does not solve anything. 
I have not been able update firmware because it won't connect to the WiFi. 

  • Link to post
    Share on other sites

    Posted · S7 won't Connect to WiFi or print

    I'd call your reseller immediately about this.

     

    But if you don't want to wait for them to get back to you, I would power down, disconnect the material station (just unplug the cable and open up the feeder levers so they can't move the filament), power back up and get things sorted such as internet, infinite loops, and firmware upgrades and only when things seem fine would I *then* reconnect the material station and close the feeder levers.

  • Link to post
    Share on other sites

    Posted · S7 won't Connect to WiFi or print

    I can't help you with the WiFi (contact reseller). 

    Maybe we can help you with the problem with the filament selection. The printer is asking for PLA Generic. 
    What filament do you have available in the Material Station? It look like a spool of Ultimaker filament. If you have loaded it and let the NFC detection do its thing, the MS will have recognised it as UM PLA blue. And since that is not the same as PLA generic, the job won't start.

    So I think the solution is either to slice for UM PLA blue, or to manually override the material to PLA generic

    • Like 2
    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...