does ultimaker s7 / cura have print recovery?

[vwang 0]

We just got a brand new Ultimaker S7 with all the bells and whistles last week. Did some smaller test prints, 2 longer overnight. Felt confident and started a 1d 23h 39m print before we left for the weekend and it apparently aborted around 1d 20h stating a Material Station Error, ER58. 

 

Is there a way to recover this print? It would be a shame to waste so much material and time to have to reprint again...

[gr5 2,189]

Not really.  Because of active leveling.  Which probes the bed in a one or two dozen places.  I know - it sucks.

 

But you can probably get the print time down by 2X by using a larger nozzle, thicker layer height, variable infill, reducing support amounts, redesigning the part, etc.