Offset between nozzle 1 and 2

[FDCW 0]

Hi, I have an Offset between nozzle 1 and 2 and I can't seem to get a good print using both nozzles.

Ultimaker S5, Rev 8.2.0,

I measured between both nozzles and I do have 22mm.

See attached pictures.

 

pls advise

[leeotts 0]

You don't really measure the offset like that. Have you tried this method of XY calibration?  XY calibration on S series printers (ultimaker.com)

[FDCW 0]

I didn't measure the offset, I measured between both nozzles to make sure that the distance was 22mm.

 

I did run the XY Cal, twice but does the Cal adjust the offset between both nozzles?

I though it only checked the XY which is not the issue here because when I use only one nozzle it prints very well.

[leeotts 0]

It might not be the nozzle offset that is the issue here. 

 

What materials are you printing with? 

 

What don't you like about the print?  

[FDCW 0]

PLA in nozzle 1 and natural PVA in nozzle 2.

 

I don't like that the PVA is printed on top of the PLA which creates defects in the final print.

[FDCW 0]

Well, I ran the XY cal again and it improved by a lot but there is still a small overlap on the X axis, I may have to add an offset to one of the nozzles.