Ok "gr5", thank you for the suggestions.
I will go for asking to the official Ultimaker support, by the way, the print has to be aborted, as I cannot way until tomorrow unfortunately.
Just a comment: I suspect this is an old quite frequent issue affecting the Material Station behaviour, never solved by Ultimaker, even if I do not understand the technical reason for which a print job cannot be resumed after a switch off (a feature that could be implemented at own risk of the user of course), or why there's no way to reset the material station in such a situation without switching off the enteir S5 Pro Bundle, aborting in this way any print job in course (another feature that a 10k expensive printer should absolutely have).
Edited by 3DL-Engineering
Recommended Posts
gr5 2,235
If it's still paused this very moment, then I'd contact support immediately. I don't know if they work weekends, plus it's already 7pm in Netherlands but they know more about this kind of thing than myself (and probably more than Dustin although he knows a lot). They will probably email you back around 8am Europe time. They all speak english quite well.
Click the 9 dots in the top right of this page, choose "support" then at the top click "submit a request" and then submit a case.
Link to post
Share on other sites