Cura 5.7 does not start on windows 10. X

[kpage29 0]

 The system is an Acer all in one desktop running intel i5 7th gen processor.

I currently have the Dremel slicer is on the machine and runs without any issues.  As I have acquired an Anycubic printer I needed to  install Cura to slice files for it to use. I went with Cura for the obvious reason that the Dremel slicer uses the same engine and similar GUI to make life much easier.

After installing 5.7 it does not start, not even a splash screen. I am hoping that it does not mean issues with the graphics driver of the system.

Any help to get this sorted out would be greatly appreciated.

stdout.logstderr.log

[Dustin 143]

From what i can tell these logs are all for Dremel slicer not UltiMaker Cura.
You will need to contact Dremel for help with that. 

As for running UltiMaker Cura it might be possible Dremel is using the same system directories as UltiMaker Cura (this has been noted to happen with other brands) which corrupts the UltiMaker Cura files.

UltiMaker and most of the community here isn't able to offer much advice for unofficial releases of UltiMaker Cura. 

[Slashee_the_Cow 303]

I don't know how well it might fulfil your needs, but for regular Cura there is a plugin for Dremel printers available in the Marketplace (button at top right of Cura).