Not able to slice

[aw26 0]

Hello, I am having problems slicing my model in Cura. The weird thing is that I put it in Cura before I scaled it up and I didn't have this problem. Now that I scaled it up, it won't slice. Any idea why this might be happening? Please let me know if you have any clue!

 

(In case the screenshot is bad)

The error says: 

 

Please review settings and check if your models:
- Fit within the build volume
- Are assigned to an enabled extruder
- Are not all set as modifier meshes

print.stl

[gr5 2,210]

The short answer is that the model is too big.  However I'm guessing the model fits within the "official specs".  So please read this as there are settings (such as brim) that you need to disable to use the full volume of the printer.  Even then, there are the clips.

 

https://support.ultimaker.com/s/article/1667337565436

[gr5 2,210]

I see you have both extruders enabled.  This reduces the printing volume significantly as explained in the above link.  For Ultimaker 3 printers only.

[aw26 0]

Thank you for sharing this with me! I am now able to slice it! Thank you again!!