UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
The short answer is that the model is too big. However I'm guessing the model fits within the "official specs". So please read this as there are settings (such as brim) that you need to disable to use the full volume of the printer. Even then, there are the clips.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,243
The short answer is that the model is too big. However I'm guessing the model fits within the "official specs". So please read this as there are settings (such as brim) that you need to disable to use the full volume of the printer. Even then, there are the clips.
https://support.ultimaker.com/s/article/1667337565436
Link to post
Share on other sites