UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Further to what @Torgeir said, it's more relevant if you're only using the basic settings window because those are all the settings that are available:
But it's still handy to quickly check what your settings are even if you're using the advanced settings.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
Torgeir 274
Hi @terrypin,
This are just the status bar for; "Infill" set to 20%, "Support" (Not used) off and "Build Plate Adhesion" (None selected) off.
This whole area open or close the "Print Setting Menu".
That's all.
Thanks
Torgeir
Edited by TorgeirMore text.
Link to post
Share on other sites
Slashee_the_Cow 454
Further to what @Torgeir said, it's more relevant if you're only using the basic settings window because those are all the settings that are available:
But it's still handy to quickly check what your settings are even if you're using the advanced settings.
Link to post
Share on other sites
terrypin 3
Thanks both, understood. BT Broadband down so far all day. Sending this from iPad via my wife’s TalkTalk router. Keen to get back to Cura on my PC.
Is there a ‘help hover’ setting I can use until I re-familiarise myself with the UI.
Link to post
Share on other sites