Hi somewhereinla,
Thank you for your post.
It is always great to get feedback, because it gives us the chance to grow and meet your expectations.
Like Ian said, I am very glad that overall you are very happy with the Ultimaker which is what matters.
But if there are things that can me improved from ordering until that point I would be happy to know.
Coincidentally, we have just made another improvement to the packaging and it is being tested now.
It mainly involves the bottom tray to make it stronger and can take higher impacts.
I do not think that the pulleys had anything to do with the rod escaping from the sliderblock.
A couple of times I have heard it before, but this usually happens during shipment, and the rod
can be very easily snapped back in place by pushing it back in. Was this as easy for you as well?
Can you let me know what the current status is with your end stop?
I am glad you have managed to get 10m3, that is a great achievement!
About the noisy fans, do you mean just the 3rd fan on the back of the printhead of also the 2 fans on the side?
The one on the back should be rather quiet, but sometimes one of the wires inside the printhead are slightly touching
the blades of the fan causing some additional noise. Could you check if it can rotate freely?
Looking forward to hear about your findings and keep us up to date about experience
Recommended Posts
ian 32
im really happy that in the end you liked your ultimaker2 printer.
It is a super 3d printer but you are right.. there are some points in the packaging that ultimaker still needs to address.
But I spotted another moderator forwarding those very concerns onto ultimaker today.. so your opinion and experiences do go back to ultimaker. :-)
If you need any help or tips with anything.. just ask on the forum and im sure you will be happily swamped with answers!
Ian :-)
Link to post
Share on other sites