Doodle3D wifi box and Cura 14.03

[ecflam 0]

Does Cura 14.03 work with Doodle3D wifi box?

I apologize if this was answered before but I could not locate the answer. I am getting blisters on my fingers plugging in and out the SD card BTW I am using ultimaker 2. Thanks.

 

[gr5 2,210]

I think maybe you have to do reprap mode. So in "file" "machine settings" you might have to change the flavor to reprap.

 

[anon4321 16]

Yes, at least in AP mode. Cura automatically "sees" the doodle3d and it shows up in place of the floppy disk icon between the load and YM icons at the top of the 3d window.

 

[ecflam 0]

OK, I will give that a try when the device arrives. Thanks.