Power supply and heated bed

[bubble_man 0]

Hello,

My problem is the following one :

I had the same problem than the one describe here : http://umforum.ultimaker.com/index.php?/topic/3735-a-fix-for-ultimaker-2-heated-bed-not-working/

Which is that the heat bed was not working due to loose cable.

So I opened the printer, I fixed the problem, I tested the heating without re-assembling everything, everything worked. I switched off, unplugged the power supply, did the re-assembly and then no power coming to the 3D printer. :???:

As we have two ultimaker 2, I connected the other power supply on the printer with the heater bed disconnected (cause it seemed to be the problem) and it worked.

To sum up :

- the power supply is dead, do you know a way to fix it ? Otherwise I will just buy a new one

- the cause of the dead power supply seems to be the heater bed. Do you know a way to test it ?

Thank you in advance for your help

 

[gr5 2,210]

Often if you let the power supply cool disconnected for a few hours it might come back to life.