Bug in 14.07

[spac3man 0]

My machine is set up as a single head machine in Cura and if I slice a model, everything is normal.

If I switch my machine to dual head and turn on the 'Ooze Shield' function and slice any model, everything is also fine.

If I switch my machine back to single head WITHOUT turning off the 'Ooze Shield' function, all models are sliced with the 'Ooze Shield' in the gcode.

I can switch machine back to dual head and turn off 'Ooze Shield', switch back to single head and slice, the model will NOT have the ooze shield in the gcode.

I just wanted to point this out.

 

[Dim3nsioneer 557]

Why do you switch back from dual head to single head? You don't have to in order to print a single extruder print. :???:

Sounds like a very rare use case to me.

 

[spac3man 0]

Regardless of why this was done , it should not happen.

 

[Dim3nsioneer 557]

I don't agree. UM / Daid has to set priorities. I prefer that known issues for common use cases get higher priority as a lot of people are affected by.

 

[Daid 306]

I don't agree. UM / Daid has to set priorities. I prefer that known issues for common use cases get higher priority as a lot of people are affected by.

 

I agree with him. This should not happen. However, does not mean I instantly will fix it. Especially as this odd behavior of invisible settings affecting the print is fixed in the PinkUnicorn re-write. (Not that that version already support dual-extrusion. But invisible settings is part of the architecture, and invisible settings fall back to defaults)