-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 27 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
LePaul 328
It looks like I am running into this issue with the dual fan upgrade I did.
I am curious what your solution was to get this resolved?
I wrapped the fan wires into the plastic wrap above the print head. That's probably the culprit in my case. On the good side, the fan wires are outside the print head so re-routing them away shouldn't be terrible (just need some clever way to secure things on there)
Are there any good, locally available (auto shop, etc?) means to wrap the wires to reduce the PWM noise? I have the wires in heat shrink tubing up to the last 4 inches, where the wire leads come into the connector.
Link to post
Share on other sites