Build volume unable to print 23cm width box

[codeczombie 0]

Hi,

I searched the forum but didn't find any similar topic.

BTW, I'll have to print a box that has one side of 23cm (which is the maximum specified in the build volume measures), when I load the stl in CURA, it's grey, then I'll have to scale it and it becomes yellow when it reaches 22.1cm width.

Is there a specific setting to reach the maximum printable width?

Thanks,

Alessandro

 

[anon4321 16]

There is a machine settings menu item that will allow you to define the machine's maximum. However, brim and skirt settings reduce this a little so you need to play with both to get the full max volume.

 

[codeczombie 0]

Thanks!

I raised it to 240mm and now it's OK.

No brim/skirt, I hope it works and doesn't fall out of the building plate.

 

[IRobertI 521]

Be careful so the print head doesn't hit the clips...