Jump to content
Sign in to follow this  
nccwarp9

Strange sound while printing

Recommended Posts

Posted · Strange sound while printing

While on a long print, >6h a strange sound started to show up.

If I pause print and wait a minute then start up again it stops but then start up again after a minute or two.

It sounds like its coming from bellow but its hard to determine exactly.

I recorded a video of it .. View My Video

Any ideas ?

Than you..

 

Share this post


Link to post
Share on other sites
Posted · Strange sound while printing

It sounds as if the feeder is skipping.

Make an ear trumpet out of a sheet of paper, and try to localize the source of the sound.

Is the feeder snapping back at the moment of the click?

 

Share this post


Link to post
Share on other sites
Posted · Strange sound while printing

Yes, feeder motor is skipping. Search around the forum. Its a common problem.

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!