Jump to content

Can not finish prints


printisans

Recommended Posts

Posted · Can not finish prints

Hi All,

I am using an Ultimaker 2 and found out it is sometimes difficult to finish a print. The first half of the print normally goes very well but it has no materials coming out from the nozzle after 2 hours print. Any ideas about what is going on? The nozzle seems ok since if I forward the material next time, it will has material coming out.

 

  • Link to post
    Share on other sites

    • 7 months later...
    Posted · Can not finish prints

    Check for free rotation of the spool. ( just posted the same answer to an earlier thread ).

    A TINY smear of Z axis grease on the top of the spool holder could work wonders.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...