UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Printen model verkleining van 0.5 lukt niet maar 0.1 e 0.3 wel
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
3dcase 37
Ha herman.
Het is een beetje raden, zo zonder fotoos, maar het zou kunnen dat je voor de gek gehouden wordt door een insect of afrondingsfoutje in Cura.
Er gebeuren soms vreemde dingen met bepaalde wanddiktes.
Stel.... je wil een wanddikte printen van 0.5mm probeer dan eens 0.4 of 0.6 of iets dergelijks.
Als ik het zo teruglees is het een vreemd antwoord op een vraag die ik er bij bedenk, Heuh.?..
Dus als je een plaatje erbij hebt
Link to post
Share on other sites