In Cura i have to touch the bottom end stop in the calibration run.....
I think Z axis is now in "software endstop" mode after the install. Meaning after homing it will only go to a certain height - something like 205mm? You can test this with pronterface.
All axis actually -- it is in this commit 
(and it is 210mm all directions)
ok. It ist not a bug it is a feature....
-
Our picks
-
UltiMaker Cura 5.8 Stable released 🎉
MariMakes posted a topic in UltiMaker Cura,
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!-
- 5 replies
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
Picked By
MariMakes, -
-
Recommended Posts
gr5 2,235
I think Z axis is now in "software endstop" mode after the install. Meaning after homing it will only go to a certain height - something like 205mm? You can test this with pronterface.
Link to post
Share on other sites