I know with code you have to be very specific in regards to line placement and spacing.
Do you have a screen shot of how its supposed to look when I type it?
Also, in my gcode tab, there are several segments to select, which one do I choose?
start.gcode
end.gcode
preSwitchExtruder.gcode
postSwitchExtruder.gcode
start2.gcode
end2.gcode
Recommended Posts
Dim3nsioneer 558
By adding a 'T1' in the gcode before the heating command (and replacing any 'T0' you can find by 'T1')... there is no other way so far in Cura atm.
Link to post
Share on other sites